01
Hose joint
End use and note whether the threaded coupling alone remains wet.
Sheet 44 / Diagnostic set
Map the outdoor connection from hose to interior
Separate hose, device, handle, spout, wall entry, interior pipe, and seasonal control.
Water at an outdoor faucet can start at the hose coupling, device, handle, spout, wall entry, interior pipe, or seasonal control. Mark the first point rather than calling the entire assembly failed.
Call about the symptom877-702-1610
INPUTOBSERVETRACEVERIFYOUTPUTRECORD
S-01Symptom named
S-02Access mapped
S-03Provider unverified
S-04Scope pending
Identify the symptom
Five callouts for this drawing
Each note describes an action, not a diagnosis. Leave unsupported branches open.
02
Device body
Describe drips from the attached fitting without adjusting an unknown part.
03
Handle stem
Watch for water only while the control moves normally.
04
Wall penetration
Check the accessible indoor side for new dampness without opening finishes.
05
Seasonal history
Add freezing periods, shutoff service, and the last connected hose use.
Trace the source
Follow evidence through the branch
Stop use if water enters the wall or interior. Give the provider freeze history, attachments, last normal use, interior moisture, and the known control record, then ask how the concealed section will be assessed.
Repair route and access map
Define the boundary before authorization
Retain the repaired component, interior area checked, product, safe operation demonstration, seasonal guidance, and wall or insulation work still required.