01
Dimension cell
Measure the opening, clearance, height, and service access before ordering.
Sheet 46 / Diagnostic set
Make product fit part of the plumbing plan
Reconcile product fit, connections, access, finishes, installation, permit, and inspection.
A replacement fixture affects dimensions, rough-in, connections, drainage, power, mounting, finishes, access, product support, and sometimes permits. Confirm conditions before purchase.
Call about the symptom877-702-1610
INPUTOBSERVETRACEVERIFYOUTPUTRECORD
S-01Symptom named
S-02Access mapped
S-03Provider unverified
S-04Scope pending
Identify the symptom
Five callouts for this drawing
Each note describes an action, not a diagnosis. Leave unsupported branches open.
02
Connection cell
Map supply, drain, vent, power, mounting, and shutoff locations.
03
Product cell
Keep the manufacturer sheet, finish, included parts, and substitution rule.
04
Finish cell
Assign responsibility for counters, cabinets, tile, floor, wall, and trim.
05
Approval cell
Ask the plumber and Town how the actual scope affects permits or inspection.
Trace the source
Follow evidence through the branch
Have the responsible plumber review the model and proposed work. Separate removal, disposal, delivery, plumbing, electrical work, cabinets, counters, tile, paint, approvals, and inspection.
Repair route and access map
Define the boundary before authorization
Close with the exact model, serial if relevant, installed parts, permit record, demonstrated operation, finish condition, care material, warranty, and remaining trade work.